Aleco Clear-Flex II with Walkin Mounting System Manual de usuario descargar pdf (Pagina 1)

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE

2720 E. Avalon Ave. Muscle Shoals, AL 35661 ● Phone (256) 248-2402 or toll free 1-800-633-3120

Fax: 1-800-750-9616 ● email: info@aleco.com ● web: www.aleco.com

P/N 477239

1110

Diagram 1

Mount Bracket

Diagram 2

Install Carriage Bolts

Diagram 3

Walk-In System

Installation Instructions

TOOLS NEEDED

• Pen or Pencil to Mark Holes

• Drill

• Crescent Wrench

• Step Stool or Ladder

• Utility Knife to Cut Strips

IMPORTANT

Prior to installation, unroll all door strips and place them on

a clean, flat surface in a warm atmosphere for a minimum of

twenty-four (24) hours. This will allow the strips to return to

their original form.

1. Mount pre-drilled Walk-In Mount to wall above

door. Use fasteners supplied by others for

mounting (Diagram 1).

2. Next, slide all the 3/8” carriage bolts down the

slot of aluminum mounting hardware (Diagram 2).

3. Starting at the left, place the first clear inside strip

(A) on the first two bolts keeping in mind the

concave pattern in Diagram 4 below. Place the

second inside strip (B) on the third and fourth

bolts and continue down the entire length

accordingly (Diagram 3).

4. Again starting at the left and using the concave

pattern, place the first outside strip (C) on the

second and third bolts. The next outside strip will

fit on the fourth and fifth bolts. Continue this

down the entire length accordingly (Diagram 3).

5. Place all washers and bolts onto screws and

tighten finger tight (Diagram 3).

6. The first strip on left is to be flush with the edge

of the aluminum hardware. Starting at this point

with the nut, tighten securely with tool. Next, take

second nut in hand and pull to the right to secure

the strip flat against the aluminum hardware.

Tighten second nut with tool. Continue this

pattern until all strips are flat and smooth and all

bolts are securely tight.

7. The strips should be initially trimmed to give a

minimum of ¼” clearance using a utility knife.

The door strips need to hang for 24 to 28

hours before the final trim to allow for proper

alignment.

Diagram 4

Indice de contenidos

Pagina 1 - Installation Instructions

FOR ANY QUESTIONS OR COMMENTS, PLEASE CONTACT AN ALECO REPRESENTATIVE 2720 E. Avalon Ave. Muscle Shoals, AL 35661 ● Phone (256) 248-2402 or toll fre

Comentarios a estos manuales

Sin comentarios

Aleco Clear-Flex II with Walkin Mounting System Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Herramientas Aleco Clear-Flex II with Walkin Mounting System. Aleco Clear-Flex II with Walkin Mounting System User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Aleco Clear-Flex II with Walkin Mounting System Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Herramientas Aleco Clear-Flex II with Walkin Mounting System. Aleco Clear-Flex II with Walkin Mounting System User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Herramientas Aleco Clear-Flex II with Walkin Mounting System